Ace Sharpening Message Forum

Please feel free to ask a question, impart some sharpening knowledge, comment on the site, or discuss any topic you would like to address this is the place to do it! If there is anything I can do to help you please ask. If I don’t know the answer to your question then hopefully someone here will be able to answer it for you. If you see a question that you know the answer to please feel free to add your answer or suggestions to any of the existing posts.

Thank you for visiting Ace Sharpening & Co!

Sharpening Message Forum Topics
Start a New Topic 
Author
Comment
View Entire Thread
Re: T- Nuts for clipper machine build

Greg,

You need to look up t-nuts for wood working. There are no t-bolts only t-nuts. the t-nuts are 1/4 -20 thread and the screws that go into them are 1/4 - 20 screws for holding the wheel inclosure onto the motor base.

James