CT MG CLUB Forum

CT MG Club Forum
Start a New Topic 
Author
Comment
Abington Spares Tech Session

I attended the Tech session held on 5/16/21 and was very impressed with the setup. Frist Ed had a car where he identified the components under the bonnet and what typical failures could occur, then he raised the car on the lift and did the same for components under the car. He also had a front end and rear end out of a car and talked about the suspension and brakes. There was also a table that had examples of the 3 type of carbs found on MG's. There was plenty of questions and information flowing back forth that I found extremely helpful.

Thank you Ed for putting this on and especially for coffee and delicious donuts

Nabil

Car Model 1970 MGB